Introduction
3
Safety Warnings
4
Symbols Used On The Instrument
5
General Description
6
Unpacking The Carton
6
Carton Contents (All Instruments)
6
Preparations For Use (All Instruments)
7
Batteries
7
Preliminary Test Lead Check
7
General Operating Instructions
8
General Functions
8
Lcd Display
9
Backlight Operation
10
Test Lead Connections
11
Standard Test Leads
11
Sp5 Switched Probe (Not Mit400/2, Mit480/2 And Mit40X)
11
Ac/Dc Voltage And Frequency Measurements
11
Insulation Resistance Testing - General
13
Standard Insulation Resistance Testing
13
Insulation Resistance Testing – Timed Modes 'T', Pi And Dar
14
Mit40X Testing
17
Continuity Testing [Ω] And Buzzer [ ]
18
Resistance Measurements (Kω Range)
19
Capacitance Measurements
20
Capacitance Measurement Procedure
20
Distance Measurement By Capacitance
20
Setup Options
20
Saving, Recalling And Downloading Test Results
23
Saving Test Results
23
Test Results Recall
23
Pi And Dar Recall
24
Deleting Test Results
26
Procedure For Deleting A Single Test Result (Refer To Figure 16)
26
Procedure For Deleting All Test Results (Refer To Figure 19)
27
Preparing Your Mit430/2 Or Mit485/2 For "Bluetooth ®" Communications
29
Preparing Your Mit430/2 Or Mit485/2 To Your Pc
29
Standard Download Operation
32
Battery And Fuse Replacement
32
Battery Condition And Replacement
32
Blown Fuse Indicator
33
Preventive Maintenance
33
Specification
34
Basic And Service Errors
36
Basic Error
36
Service Error
36
Accessories
37
Repair And Warranty
39
Discussie
Laat een opmerking achter of stel een vraag
Hallo, ik gebruik de MIT410/2 voor isolatiemetingen maar na een meting zie ik dat het apparaat nog steeds spanning op de kabel houdt. Hoe lang moet ik wachten voordat ik de testleidingen veilig kan loskoppelen? Het ontlaadt wel automatisch toch?
Ja, de MIT410/2 heeft een automatische ontlaadfunctie, maar je moet het apparaat aangesloten laten totdat de spanning is teruggelopen naar een veilig niveau. Dit kan bij grotere capacitieve circuits even duren. Kijk in het manual bij de veiligheidswaarschuwingen, daar staat duidelijk vermeld dat je verbonden moet blijven totdat het circuit volledig is ontladen. Vertrouw niet alleen op de automatische ontlading als extra veiligheid, maar behandel het altijd als aanvullend op je normale werkprocedure.
Doe mee aan de discussie
Stel een vraag over de handleiding of voeg een nuttig antwoord toe voor andere gebruikers.