GE GTDL740GDWW Wasdror Wasdrogers Handleiding

Oorzaak: Some shaking/noise is normal. Dryer may be sitting unevenly

Move dryer to an even floor space, or adjust leveling legs as necessary until even.

Oorzaak: Improper use of fabric softener

Follow directions on fabric softener package.

Oorzaak: Drying dirty items with clean ones

Use your dryer to dry only clean items. Dirty items can stain clean items and the dryer.

Oorzaak: Clothes were not completely clean before drying

Sometimes stains which cannot be seen when the clothes are wet appear after drying. Use proper washing procedures before drying.

Oorzaak: Lint filter is full

Clean lint screen before each load.

Oorzaak: Improper sorting

Sort lint producers (like chenille) from lint collectors (like corduroy).

Oorzaak: Static electricity can attract lint

See suggestions in this section under Static occurs.

Oorzaak: Overloading

Separate large loads into smaller ones.

Oorzaak: Paper, tissue, etc., left in pockets

Empty all pockets before laundering clothes.

Oorzaak: No fabric softener was used

Try a fabric softener. Bounce® Fabric Conditioner Dryer Sheets have been approved for use in all GE Dryers when used in accordance with the manufacturer's instructions.

Oorzaak: Over-drying

Try a fabric softener. Adjust setting to Less Dry or Damp.

Oorzaak: Synthetics, permanent press and blends can cause static

Try a fabric softener.

Oorzaak: Type of heat

Automatic drying times will vary according to the type of heat used (electric, natural or LP gas), size of load, types of fabrics, wetness of clothes and condition of exhaust ducts.

Oorzaak: Load consists of a mixture of heavy and light fabrics

When combining heavy and light fabrics in a load, choose More Dry if you are using a sensor cycle.

Oorzaak: Exhaust system is blocked

Inspect and clean exhaust system.

Oorzaak: Improper sorting

Separate heavy items from lightweight items (generally, a well-sorted washer load is a well-sorted dryer load).

Oorzaak: Large loads of heavy fabrics (like beach towels)

Large, heavy fabrics contain more moisture and take longer to dry. Separate large, heavy fabrics into smaller loads to speed drying time.

Oorzaak: Controls improperly set

Match control settings to the load you are drying.

Oorzaak: Lint filter is full

Clean lint filter before every load.

Oorzaak: Improper or obstructed ducting

Check Installation Instructions for proper ducting/venting. Make sure ducting is clean, free of kinks and unobstructed. Check to see if outside wall damper operates easily. Check the Installation Instructions to make sure the dryer venting is correct.

Oorzaak: Blown fuses or tripped circuit breaker

Replace fuses or reset circuit breakers. Electric dryers use 2 fuses/breakers, make sure both are operating.

Oorzaak: Overloading/combining loads

Do not put more than one washer load in the dryer at a time.

Oorzaak: Under-loading

If you are drying only one or two items, add a few items to ensure proper tumbling.

Oorzaak: Over-drying

Select a shorter drying time. Remove items while they still hold a slight amount of moisture. Select a Less Dry or Damp Dry setting.

Oorzaak: Letting items sit in dryer after cycle ends

Remove items when cycle ends and fold or hang immediately.

Oorzaak: Overloading

Separate large loads into smaller ones.

Oorzaak: Some fabrics will naturally shrink when washed. Others can be safely washed, but will shrink in the dryer

To avoid shrinkage, follow garment care labels exactly. Some items may be pressed back into shape after drying. If you are concerned about shrinkage in a particular item, do not machine wash or tumble dry it.

Oorzaak: The dryness monitor senses that the body of the clothes is dry

Choose Speed Dry or Timed Dry to dry damp collars and waistbands. In the future, when drying a load with collars and waistbands, choose More Dry.

Oorzaak: Loose water hose connection to valve

Tighten connection.

Oorzaak: Hose missing rubber washer at connection with valve

Install rubber washer provided with hose.

Oorzaak: Dryer is continuously monitoring the amount of moisture in the clothes

This is normal. When the dryer senses a low level of moisture in the load, the dryer will display the dry time remaining.

Oorzaak: The estimated time may change when a smaller load than usual is drying

This is normal.

Oorzaak: The Extended Tumble option was chosen

This is normal. During Extended Tumble option, the time remaining is not displayed. The extended tumbling option lasts approximately 60 minutes.

Oorzaak: The door was opened mid-cycle. The load was then removed from the dryer and a new load put in without selecting a new cycle

A dry cycle must be re-selected each time a new load is put in.

Oorzaak: Small load

When drying 3 items or less, choose Speed Dry or Timed Dry.

Oorzaak: Load was already dry except for collars and waistbands

Choose Speed Dry or Timed Dry to dry damp collars and waistbands. In the future, when drying a load with collars and waistbands, choose More Dry.

Oorzaak: Dryer is not level

Move dryer to an even floor space or adjust leveling legs as necessary until even.

Oorzaak: Very small load (such as one item) is not activating the dry sensor

Use the Timed Dry cycle option, select the desired dry time.