Haier HWD100-B14959NU1 Wasdroger Handleiding

Drying motor error

Contact the After sales service.

Drying water level is too high

Contact the After sales service.

Water overflowed abnormally

Contact the After sales service.

Drainage error. Water is not fully drained within 1 minute (i-Refresh programme)

Clean pump filter. Check drain hose installation.

Lock error

Shut the door properly.

Water level not reached after 8 minutes

Make sure that tap is fully opened and water pressure is normal. Check drain hose installation.

Water protective level error

Contact the After sales service.

Drying temperature is too high

When temperature exceeds 80°C the drying alarm, when less than 80°C the automatic lifting of the alarm.

Temperature sensor error

Contact the After sales service.

Heating error

Contact the After sales service.

Motor error

Contact the After sales service.

Dry temperature sensor error

Contact the After sales service.

Oorzaak: No water

Check water tap.

Oorzaak: Inlet hose is kinked

Check inlet hose.

Oorzaak: Inlet hose filter is blocked

Unblock inlet hose filter.

Oorzaak: Water pressure is less than 0.03 MPa

Check water pressure.

Oorzaak: Door is not properly closed

Close the door properly.

Oorzaak: Water supply failure

Ensure the water supply.

Oorzaak: Height of drain hose is below 80 cm

Make sure that drain hose is properly installed.

Oorzaak: Drain hose end could reach into water

Make sure the drain hose is not in water.

Oorzaak: Drain hose is blocked

Unblock drain hose.

Oorzaak: Pump filter is blocked

Clean pump filter.

Oorzaak: Drain hose end is higher than 100 cm above floor level

Make sure that drain hose is properly installed.

Oorzaak: Not all transportation bolts have been removed

Remove all transportation bolts.

Oorzaak: Appliance has no solid position

Ensure solid ground and a levelled position.

Oorzaak: Machine load is not correct

Check load weight and balance.

Oorzaak: Water or electric failure

Check power and water supply.

Oorzaak: Appliance displays error code

Consider display codes.

Oorzaak: Problem due to load pattern

Reduce or adjust load.

Oorzaak: Programme performs soaking cycle

Cancel programme and restart.

Oorzaak: Detergent is not appropriate

Check detergent recommendations.

Oorzaak: Excessive use of detergent

Reduce amount of detergent.

Oorzaak: Washing programme duration will be adjusted

This is normal and doesn't affect functionality.

Oorzaak: Unbalance of laundry

Check machine load and laundry and run a spinning programme again.

Oorzaak: Degree of pollution does not agree with selected programme

Select another programme.

Oorzaak: Detergent quantity was not sufficient

Choose the detergent according to the degree of pollution and according to manufacturer specifications.

Oorzaak: Maximum load has been exceeded

Reduce loading.

Oorzaak: Laundry was unevenly distributed in the drum

Loose the laundry.

Oorzaak: Insoluble particles of detergent can remain as white spots on the laundry

Perform extra rinse. Try to brush the points from the dry laundry. Choose another detergent.

Oorzaak: Caused by fats such as oils, creams or ointments

Pretreat the laundry with a special cleaner.