Bosch SMV25BX03R Vaatwasser Handleiding

Oorzaak: Filter system or area under the filters blocked, or programme has not ended yet

Clean filters and area underneath. Wait until programme ends or reset.

Oorzaak: No or too little rinse aid, programme selected without drying, water collecting in depressions, combined detergent has poor drying performance, intensive drying not activated, utensils removed too early, eco rinse aid used

Refill rinse aid. Select programme with drying. Arrange utensils in sloping position. Use different combination detergent with better drying performance. Activate intensive drying. Wait until program ends or wait 30 min after program ends before removing utensils. Use proprietary rinse aid instead of eco products.

Oorzaak: Special properties of plastic - lower heat storage capacity

This is normal behavior for plastic utensils.

Oorzaak: Cutlery not arranged properly in basket or drawer

Separate cutlery if possible, prevent contact points. Arrange cutlery properly in drawer.

Oorzaak: No appliance fault - normal condensation drying process

This is normal. Water droplets are physically induced and required. Humidity condenses on inner walls, drains and is pumped out.

Oorzaak: Utensils placed too closely together, spray arm rotation obstructed, spray arm nozzles blocked, filters dirty, filters inserted incorrectly, rinse programme too weak, utensils precleaned too intensely, stubborn soiling, tall narrow receptacles not rinsed, top basket not set to same height

Arrange utensils with adequate clearance. Arrange utensils so spray arm can rotate freely. Clean spray arm nozzles. Clean filters. Insert and engage filters correctly. Select more intensive rinse programme. Do not prerinse utensils, remove only large food remnants. Select Eco 50° or Intensive programme. Do not place hollow receptacles too obliquely or in corner area. Set top basket to same height using side levers.

Oorzaak: Detergent dispenser cover blocked by utensils, tablet inserted upright, tablets used in quick or short programme, dissolving time not reached, detergent has poor performance or is lumpy

Do not obstruct detergent dispenser cover with utensils. Do not place utensils or fragrance dispenser in tablet collecting tray. Insert tablet flat, not upright. Use detergent powder or select more intensive programme. Change detergent.

Oorzaak: Droplet formation on plastic surface is physically unavoidable

Use more intensive programme (more water changes). Arrange utensils in sloping position. Use rinse aid. If required, increase softening setting.

Oorzaak: Detergent substances are deposited

Change detergent brand. Clean appliance mechanically. If white coating on container floor, increase softening setting and change detergent if required.

Oorzaak: Salt dispenser cover not closed correctly

Close salt dispenser cover correctly.

Oorzaak: Detergent substances deposited, hardness range incorrectly set or water hardness greater than 8.9 mmol/l, 3 in 1 detergent ineffective, underdosing of detergent, too weak rinse programme

Change detergent brand. Clean appliance mechanically. Set water softening system according to instructions or top up salt. Use separate detergents (proprietary detergent, salt, rinse aid). Increase detergent dosage or change detergent. Select more intensive rinse programme.

Oorzaak: Too low rinsing temperature, too little or unsuitable detergent, utensils precleaned too intensely

Select programme with higher washing temperature. Use suitable detergent at correct dosage. Do not prerinse utensils. Remove only large food remnants. Select Eco 50° programme or more intensive programme.

Oorzaak: Film formation from vegetable ingredients or tap water containing manganese, or metallic components on silver or aluminium utensils

Can be partly removed with machine cleaner or by mechanical cleaning. Coatings are harmless.

Oorzaak: Film formation from food remnants and tap water substances (limescale)

Check function of water softening system (refill with salt) or activate water softening system if using combined detergents (tablets).

Oorzaak: Plastic parts may become discoloured during service life

This is normal and will not impair the function of the dishwasher.

Oorzaak: Too low rinsing temperature, utensils precleaned too intensely

Select programme with higher washing temperature. Do not prerinse utensils. Remove only large food remnants. Select Eco 50° programme or more intensive programme.

Oorzaak: Too much rinse aid, no rinse aid added or setting too low, detergent residue in final rinse, detergent dispenser cover blocked, utensils precleaned too intensely

Set rinse aid amount to lower setting. Add rinse aid and check dosage (recommended setting 4-5). Do not obstruct detergent dispenser cover. Do not place utensils or fragrance dispenser in tablet collecting tray. Do not prerinse utensils. Remove only large food remnants.