Asko DWCBI231W Vaatwasser Handleiding

Water level fault

Clean the coarse and fine filters. Check that the outer filter on the inlet hose is not blocked. If the problem persists, call the service department.

Overfilling water

Turn off the water tap and call the service department.

Circulation pump fault

Call the service department.

Oorzaak: Incorrect rinse aid dosage setting, TAB setting activated with insufficient drying detergent, empty salt compartment, incorrect water softener setting, leaking water softener, or high temperature and excess detergent on crystal

Check rinse aid dosage in Settings. Switch all-in-one detergents or deactivate TAB setting and top up with salt and separate rinse aid. Top up salt compartment. Adjust water softener setting. Check salt compartment lid is properly tightened. Wash crystal at low temperature with conservative detergent amount.

Oorzaak: Rinse aid dosage setting too high

Reduce the dosage in Settings. If you have very soft water, dilute the rinse aid 50:50 with water.

Oorzaak: Lipstick and tea difficult to wash off

Use a detergent with a bleaching agent.

Oorzaak: Detergent compartment was damp when adding detergent or compartment has been blocked

Ensure the detergent compartment is dry when adding detergent. Check that dishes are not preventing the detergent compartment from opening.

Oorzaak: Dishes not correctly placed or spray arms not rotating

Check that dishes are placed securely. Spin the spray arms to make sure they can rotate.

Oorzaak: Filters blocked or not fitted correctly, debris in drainage pump, drainage pump stop missing, kink in drainage hose, or blocked drainage hose

Clean the coarse and fine filters. Check filter handle is locked in stop position. Clean the drainage pump. Verify coloured stop in bottom drain is in place. Check drainage hose is free from kinks and sharp bends. Disconnect drainage hose at sink connection and check for debris and minimum 14 mm inner diameter.

Oorzaak: Dirt around seals and in corners, or low temperature programmes selected for prolonged period

Clean with washing-up brush and low foaming cleaner. Run a programme with higher temperature once or twice a month, or run a self-cleaning programme.

Oorzaak: Dishwasher not fully loaded, rinse aid needs topping up or dosage too low, TAB setting activated with insufficient drying detergent, or door not opened slightly after programme

Fully load the dishwasher. Top up rinse aid or increase dosage level in Settings. Switch all-in-one detergents or deactivate TAB setting and top up with salt and separate rinse aid. Open the door a little once the programme has finished.